Craig Hogarth
10-20-2007, 11:43 PM
I've been doing a lot of plastic lately and on occasion, in the middle of a job, the laser is unable to raster through the cap. I end up stopping the job, and starting a new one with a little more power and engraving bottom up.
I had it happen on marble once a month ago, but I think that was a bad file. Now it only happens on plastic. I'm wondering if I'm losing power in the middle of a job or maybe it's the way the plastic was made.
any ideas?
I had it happen on marble once a month ago, but I think that was a bad file. Now it only happens on plastic. I'm wondering if I'm losing power in the middle of a job or maybe it's the way the plastic was made.
any ideas?