Jeff Cremers
10-15-2007, 12:39 PM
I just recieved a 14 inch grizzly G055 and bought the riser for it well the blade that came with the riser kit is a 105" and its tight, really tight. I had to losen it all the way just to get it on and then tilt the wheel to get it to the middle. I forgot to put tension back on and it still cut fine its so tight. so my questions are
Has anyone else had this issue adn did you just remeasure for when you bought new blades and could this tight blade be a problem.
Is the best way to meausre from center of the wheel to center of the wheel and then add 1/2 of the wheel width or just measure the old blade and with a string or by marking it and then add a little?
Thanks
Jeff
Has anyone else had this issue adn did you just remeasure for when you bought new blades and could this tight blade be a problem.
Is the best way to meausre from center of the wheel to center of the wheel and then add 1/2 of the wheel width or just measure the old blade and with a string or by marking it and then add a little?
Thanks
Jeff