View Full Version : Frequency settings
Dave West
10-13-2007, 9:58 AM
I'm looking at the print driver ( WinXP) I'll use on my Epilog Profile and I dont see a setting for frequency. Did older lasers have a variable setting?
Just trying to figure everything out before I get it hooked up next week.
Thanks,
Dave
Dave West
10-13-2007, 10:30 AM
I might of found it. There's a setting for 'Rate' in the Vector portion of the driver that goes from 1 to 100.
Dave
Mike Null
10-13-2007, 11:14 AM
It may be called PPI on your machine.
Peck Sidara
10-15-2007, 9:40 AM
Dave,
On the Profile/Radius win32 engraver print driver, rate is the same as frequency. Whereas on newer machines, it's called frequency. Cutting at a lower rate will result in a preforated cut. Cutting at a rate of 100 is what you'll want to use on acrylic.
HTH,
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.