C Scott McDonald
10-10-2007, 4:49 PM
Hey folks,
I need to square a bunch of 21x36 solid hardwood panels. If I get the festool MFT 1080 is there enough room between the holes to clamp a 21" panel for crosscutting? I understand the panel is 28" wide but the wholes look like the are in at least 2 to 3"s in for the edge.
Thanks!
Scott
I need to square a bunch of 21x36 solid hardwood panels. If I get the festool MFT 1080 is there enough room between the holes to clamp a 21" panel for crosscutting? I understand the panel is 28" wide but the wholes look like the are in at least 2 to 3"s in for the edge.
Thanks!
Scott