Jim Dunn
10-09-2007, 10:06 PM
I have an X5 6" Delta jointer. I need to adjust the knives. Using the tools supplied with the jointer I don't seem to have the right size wrench. The set screws that hold the knives tight are supposed to be 8mm. I base that on the fact that I don't have a 9mm wrench. But the 8mm is to small.
Anyone with this type of jointer what size wrench do you use to loosen the knives for adjustment?:confused:
Anyone with this type of jointer what size wrench do you use to loosen the knives for adjustment?:confused: