Joe Pelonio
10-05-2007, 2:52 PM
I was running a batch of name tags using the top third of a 12x24 sheet of laminate. The phone rang so I wasn't watching it, but when the engraving finished and I looked the first and last 4 columns were great, but on all the ones in the center the letters were all wide and flat like it was out of focus.
I thought it must be time to clean the sensor strip or something but when I took out the vector grid, just by chance I noticed this on the bottom.
Wondered where that went!
I thought it must be time to clean the sensor strip or something but when I took out the vector grid, just by chance I noticed this on the bottom.
Wondered where that went!