A chuckle for you (at my expense)

[Joe Pelonio]

I was running a batch of name tags using the top third of a 12x24 sheet of laminate. The phone rang so I wasn't watching it, but when the engraving finished and I looked the first and last 4 columns were great, but on all the ones in the center the letters were all wide and flat like it was out of focus.

I thought it must be time to clean the sensor strip or something but when I took out the vector grid, just by chance I noticed this on the bottom.

Wondered where that went!

[Dave Fifield]

Easily done Joe. You have to drill yourself to check that you took everything out before you put the workpiece in....like crossing the road (look left, look right, look left again...) ;)

[Leigh Costello]

Give him a "T" ! Oh wait, he has one! Just kidding, Joe. At least it wasn't something that could hurt you.