Stephen Sebed
03-03-2003, 5:16 PM
I have been looking for what I think is a Rail and Stile router bit. what I want to do is cut a groove for 1/4 inch plywood to sit in. I would like to have a matching Rail and Stile set. Also, since I don't have room for a router table, Can I get these bits with bearings? I have looked on amazon and found one set that I think would work, here is the web address.
http://www.amazon.com/exec/obidos/tg/detail/-/B00006XMTT/qid=1046729499/br=1-1/ref=br_lf_hi_1//103-5131616-7980610?v=glance&s=hi&n=3116551
I'm not sure if that set has 1/4 or 1/2 inch shanks and if both bits have bearings. I was also hoping I could find a set for $50 or less (I know I'm cheap)
If anyone could point me in the direction to other websites that I could check, I would appreciate it.
Thanks,
http://www.amazon.com/exec/obidos/tg/detail/-/B00006XMTT/qid=1046729499/br=1-1/ref=br_lf_hi_1//103-5131616-7980610?v=glance&s=hi&n=3116551
I'm not sure if that set has 1/4 or 1/2 inch shanks and if both bits have bearings. I was also hoping I could find a set for $50 or less (I know I'm cheap)
If anyone could point me in the direction to other websites that I could check, I would appreciate it.
Thanks,