Paul Engle
10-03-2007, 8:44 PM
Ok , ok , last one, this is my 5/8 Ellsworth Crown, 5/8 COMP. x 3/4 FIP PIPE ADAPTER , 3/4 X 18 black pipe and 1" clear hose, I had to grind of the black crud on the pipe and grease it up to get it on as is 1 in hose and the pipe od is 63/64ths I swear....I stoped short as I did not get a cap for it... yet I will see how I like this arrangement , I started another walnut hf but can't find the pic :o but will post , drilled out the comp with silver-deming this time as no 5/8 brad point ( that out make some of ya happy :D ) if you do go this route pleaseeeee , clamp in vise on drill press as bit does not like to redrill large hole ... ever so slighty please. Total cost was $14.52 plus tx. and about 30 minutes. oh the Ellsworth handle I only toasted 2 inches of it so is good for something that will last longer. Thanks for lookin and putin up with this series.