Performax 16-32 drum sander owner manual

[Thong Nguyen]

Hi, I just bought a used sander, I would like to change the sand paper, but the part "how to" in the manual that the seller gave me is missing. Any help would be much appreciated.

[Joe Mioux]

pm me your address or fax number, I will try to fax that info to you tomorrow.

Joe

[John Terefenko]

Not much to it. If you bought roles where you have to cut it yourself just take out the old one and use that as a pattern and cut to length. When taking paper out start at the right spring clip and unroll to the left and when installing start just the opposite. If you bought strips that are precut just install the exact way the old paper is paying attention to the amount of paper left under the clips and the angle it is wraped on the drum. Make sure you do not overlap. It should lay side by side as you wrap on the drum. Hope this helps.

[Greg Crawford]

I think it's available as a PDF from WMH tool group.

[Thong Nguyen]

Thank you all for your help, and thank you Joe for sent me the instruction that I needed.
Thong N.