Bob & Elaine Robinson
10-01-2007, 5:36 PM
I will be getting my ULS laser next month (a 50w 360) and was wondering if anyone out there has used Canvas 10 instead of Corel Draw. I have been a user of Canvas since it's inception, primarily on a Mac. I currently run version 10 on my Mac and the Windows version of 10 on an old notebook PC with XP.
While I was testing out lasers , I used EPS saves of my Canvas files. Those folks who tested my files on their lasers would open the Canvas EPS files in Corel (or Autocad) and then run them through the driver.
If I have this right, I understand that any (windows) graphics program can be used with the ULS drivers. As the notebook PC is old, fragile and temperamental, I will be installing the windows version of 10 on my Intel (Core2) Mac running Windows XP pro (sp2) under Bootcamp. This will be what I will using for the laser.
Any thoughts or recommendations?
Bob
While I was testing out lasers , I used EPS saves of my Canvas files. Those folks who tested my files on their lasers would open the Canvas EPS files in Corel (or Autocad) and then run them through the driver.
If I have this right, I understand that any (windows) graphics program can be used with the ULS drivers. As the notebook PC is old, fragile and temperamental, I will be installing the windows version of 10 on my Intel (Core2) Mac running Windows XP pro (sp2) under Bootcamp. This will be what I will using for the laser.
Any thoughts or recommendations?
Bob