Craig Thompson
09-17-2007, 11:20 PM
I was getting a little jealous of repeatedly logging on to see everyone elses gloats.. So I went out and parted with some cash just to post:D .
1st, Thanks to Aaron Hamilton, I found a long wanted addition to the shop. Kregg DK3100, 3 spindle pocket machine... yeah I know that it isn't a Kastle.. but it's still faster than one at a time. Not to mention monkying around with the manual clamps, etc, etc.
2nd, Since I crippled my old shop vac with a torpedo heater last winter on a job site.... ( almost as funny as it was scary ), and my 15 yr old dewaly ROS died a couple days ago.... I had to decide between a fein or festool system. Based on all of your ranting and raving.. I went with the Festool... CT33 and ETS 150/5.... used it tonight... love it, so far.
3rd, new vac system, I currently do not have the room for any machine that isn't moveable, so I went with the PM Dual Canister unit. 1900 CFM. Ran all the ductwork over the last week.. Ran some newly acquired Cherry for the next job, and it works great.
1st, Thanks to Aaron Hamilton, I found a long wanted addition to the shop. Kregg DK3100, 3 spindle pocket machine... yeah I know that it isn't a Kastle.. but it's still faster than one at a time. Not to mention monkying around with the manual clamps, etc, etc.
2nd, Since I crippled my old shop vac with a torpedo heater last winter on a job site.... ( almost as funny as it was scary ), and my 15 yr old dewaly ROS died a couple days ago.... I had to decide between a fein or festool system. Based on all of your ranting and raving.. I went with the Festool... CT33 and ETS 150/5.... used it tonight... love it, so far.
3rd, new vac system, I currently do not have the room for any machine that isn't moveable, so I went with the PM Dual Canister unit. 1900 CFM. Ran all the ductwork over the last week.. Ran some newly acquired Cherry for the next job, and it works great.