View Full Version : Changing speed of 14" Delta Bandsaw
Greg Funk
09-13-2007, 7:48 PM
I am selling an older 14" Delta (28-275C) bandsaw. A potential buyer would ideally like to have a blade speed of 1500fpm. Currently it has a 1725RPM motor, a 2.8" drive pulley and a 6" driven pulley.
My calcluations indicate it is currently running around 2850fpm and that to change it to 1500 would require a 12" driven pulley or perhaps changing to 2"/8" drive/driven pulleys.
Does anyone have any experience in doing this? Is there a minimum size for the drive pulley? Or is there some simple alternative method of reducing the speed.
thanks,
Greg
Ted Illi
09-13-2007, 8:08 PM
Take a look at this site. http://gadi.agric.za/software/renting/pulley.php It should give you all the information you are looking for.:)
Greg Funk
09-13-2007, 8:15 PM
Thanks Ted but that site doesn't provide any details on the minimum size for a v-belt pulley. At some size I suspect it becomes difficult to efficiently transfer sufficient power (3/4HP).
Greg
Chris Rosenberger
09-13-2007, 8:26 PM
Have you checked into a 1140 rpm motor & larger pulley?
Richard Butler
09-13-2007, 11:23 PM
The way I have set it up on my Delta Bandsaw is to put a 3 phase motor and a VFD on it. Works very well. If you need a calculator, this one works well.
http://www.owwm.com/Math/SFPM.asp
Greg Funk
09-14-2007, 12:37 PM
Have you checked into a 1140 rpm motor & larger pulley?
Thanks Chris. I had a quick look and I'll certainly recommend that as a possible solution. It looks like they are close to double the price of a 1725RPM motor.
The way I have set it up on my Delta Bandsaw is to put a 3 phase motor and a VFD on it. Works very well. If you need a calculator, this one works well.
http://www.owwm.com/Math/SFPM.asp
Another good option. Thanks!
Pete Bradley
09-14-2007, 1:38 PM
You should have no problem selling that saw. I'm assuming this prospective buyer wants to be sure it can be changed to suit him. I would not change it as the seller.
If 2"/8" will fit inside the belt guard, it could be done but he'd want a cogged (AX) belt in order to get around the small pulley.
Pete
Greg Funk
09-14-2007, 3:16 PM
You should have no problem selling that saw. I'm assuming this prospective buyer wants to be sure it can be changed to suit him. I would not change it as the seller.
If 2"/8" will fit inside the belt guard, it could be done but he'd want a cogged (AX) belt in order to get around the small pulley.
Pete
Thanks Pete,
No I wasn't planning to make any changes I just want to eliminate any potential obstacles.
Greg
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.