Jason Morgan
09-05-2007, 8:56 PM
I recently purchased a Ridgid 12" compound miter saw with laser guide. It was the factory laser, not an aftermarket and I have a question for those of you with laser guides.
I cannot seem to get it lined up. When I line it up with the saw in the full upright, the laser moves sideways as I bring it down. Is this normal? It would actually be very accurate if I always remember to align the piece with the saw completely up. I've checked the saw for square and its square on both angles (with my GROZ square).
I watch Norm use his saw laser and it cust right through the line during the whole cut.
Any advice?
Thanks
I cannot seem to get it lined up. When I line it up with the saw in the full upright, the laser moves sideways as I bring it down. Is this normal? It would actually be very accurate if I always remember to align the piece with the saw completely up. I've checked the saw for square and its square on both angles (with my GROZ square).
I watch Norm use his saw laser and it cust right through the line during the whole cut.
Any advice?
Thanks