Al Mutairi
08-31-2007, 8:52 PM
I remember one of our members posting on this forum his/her experiences on how to build a Vacuum Table for the laser, this was maybe a year back , I tried to locate it but had no luck!
I am doing some paper cutting work & I am having a problem getting the paper to stay flat & because of the air assist some of the inner cut pieces fly over to yet to be cut areas causing poor cuts when the laser passes over those areas.
I did a web search & found this site http://debece.net/pages/propts.htm & it seems the tables they are offering are easy to duplicate only if I could figure out what the internals are ?
The cutting table I use is called the Laser Launch Pad , it's easily removable & I think there is enough room underneath to fit the vacuum table . I haven't figured out how to run the hoses out to the vacuum cleaner & by doing so wouldn't that suck the somke out & pollute the room ?
Help is sought on ideas & the most economical way to approach this project .
Regards to all,
Al
http://debece.net/images/fullsize.JPG
I am doing some paper cutting work & I am having a problem getting the paper to stay flat & because of the air assist some of the inner cut pieces fly over to yet to be cut areas causing poor cuts when the laser passes over those areas.
I did a web search & found this site http://debece.net/pages/propts.htm & it seems the tables they are offering are easy to duplicate only if I could figure out what the internals are ?
The cutting table I use is called the Laser Launch Pad , it's easily removable & I think there is enough room underneath to fit the vacuum table . I haven't figured out how to run the hoses out to the vacuum cleaner & by doing so wouldn't that suck the somke out & pollute the room ?
Help is sought on ideas & the most economical way to approach this project .
Regards to all,
Al
http://debece.net/images/fullsize.JPG