Brian Robison
08-21-2007, 3:48 PM
OK, I'm at my wits end.
I've got a job that's a painted part that needs a part #
I was going to just laser through the top of the paint
and leave a light mark. Turns out the paint thickness
isn't consistent enough. So I burned through the
paint on some parts. Next option, laser through the paint, Cermark and laser again. Mark doesn't stick, turns out the part is aluminum
not steel. Next I'm trying to oxidize the parts with marginal results. I'm thinking about masking and painting next. Any one have any ideas?
I've got a job that's a painted part that needs a part #
I was going to just laser through the top of the paint
and leave a light mark. Turns out the paint thickness
isn't consistent enough. So I burned through the
paint on some parts. Next option, laser through the paint, Cermark and laser again. Mark doesn't stick, turns out the part is aluminum
not steel. Next I'm trying to oxidize the parts with marginal results. I'm thinking about masking and painting next. Any one have any ideas?