Rockwell 34-476 unisaw

[Thomas Meredith]

Can anybody give me any info or a link to any info on this particular saw with a delta 2hp motor I have done a ton of searches and cannot find anything. I think from the serial number HM69XX it was made somewhere from 1975 to 1976 the motor is a model 83-631
Thanks

[Rick Cabot]

You may find this link to be helpful. Good luck.

http://www.owwm.com/MfgIndex/Detail.asp?Tab=Publications&ID=698

Rick Cabot

[Josiah Bartlett]

I have that exact saw, I've found it to be a reliable workhorse, although I did have to true up the face of the arbor when I got it a few years ago. What would you like to know about it?

[Thomas Meredith]

basically are there any differences between this saw and the 34-450 and if it is as good as or close to the current made unisaws also how the older 2hp motor compares to the newer 3 and lastly if this saw was made before rockwells quality seemed to fall off sometime in the late 70s

[Josiah Bartlett]

qAs long as it hasn't been abused, it is as good or better than a new one. There are motor upgrades available for these saws- there was a 5hp 3-phase unit available at the time, and the new 3-hp motor and controls will bolt on. However, I find that my 2-horse is quite adeqate for what I do. If it cuts straight and doesn't vibrate excessively its fine. Other than the arbor bearings, all the parts on this saw interchange with whats on a new one.

You may want to upgrade the fence, the Jet-locks work ok until they get bent or wear out. Once that happens they fight you.

[Thomas Meredith]

Thanks for the reply that all sounds pretty good to me the fence has already been taken care of for me it comes with a 52" unifence and table so hopefully I did alright I will know for sure this weekend

[Brandon Davis]

Can anybody give me any info or a link to any info on this particular saw with a delta 2hp motor I have done a ton of searches and cannot find anything. I think from the serial number HM69XX it was made somewhere from 1975 to 1976 the motor is a model 83-631
Thanks

I have a parts-list for the model number 34-476 and it says it was revised in 1985.

[thomas hill]

Do you still have that parts list? I'm looking for a 34-476 parts list.

Thanks

[Bill Geibe]

Looks like a 1975 model: http://wiki.vintagemachinery.org/DeltaSerialNumbers.ashx

Here's an exploded view and parts list: http://www.toolpartsdirect.com/cgi-bin/schematic.cgi/delta/34-476

Bill