Hold Down Clamp

[Kendall Landry]

I've been looking at Felder sliding tables and don't see any mention of hold down clamps. Does Felder have one for their sliding tables?

[Jamie Buxton]

There's a very active Felder forum on Yahoo Groups. finance.groups.yahoo.com/group/felder-woodworking

[Gary Curtis]

The Felder machinery tops have T-slots milled into them to accept hold-down clamps. We used the clamps to do some milling on the shaper at a Felder seminar in Sacramento this May. These clamps have a half-inch steel bar and are about 3-times the heft and strength of clamps found on domestic machinery.

Gary Curtis:)