aaron allen
07-27-2007, 10:45 AM
Occasionally I hafta build with laminate. One current customer showed me a bevel edge treatment she would like. I have done such edges before but the corner was a bit different. For the life of me I can't figure an efficient way to cut the corner. Help.
The beveled edge is mitered at 45 degrees but the face or dropped front has a small 22.5 degree three sided turn at the corner. Its not the corner shown on a popular bevel edge website. Sorry I can't provide a drawing or picture at this time. Any help or re-direct would be much appreciated. :D
The beveled edge is mitered at 45 degrees but the face or dropped front has a small 22.5 degree three sided turn at the corner. Its not the corner shown on a popular bevel edge website. Sorry I can't provide a drawing or picture at this time. Any help or re-direct would be much appreciated. :D