Half round table

[Scott LeBlanc]

I'm about to start a half round table with three legs for my mother and I have never worked with a round apron. Can someone tell me or point me to an article/thread that explains how to attach legs to a round apron? I would assume notch them for the front overlap ... but how do you acheive a tight fit against the curve? Sand them into shape? And then would you suggest glue and lag them from the inside? Any help would be appreciated.

[Larry Crim]

Scott
Send me your email address via PM, if you want I have a few book articles I can send you that may give you a few ideas.
Larry

[Larry Crim]

sent 3 emails hope they make it not sure if your yahoo email can take them they are PDF's
Larry

[Scott LeBlanc]

Got'em ... thanks alot. Great stuff.

[Henry Cavanaugh]

The Front Cover of FWW 12-2005 is a Federal card Table by Steve Latta. Shows attaching legs to curved apron.