PDA

View Full Version : Which Manufacturer is this?


Robert Conner
07-18-2007, 12:19 AM
I got this "sled" " feed table" with the Unisaw I purchased. Not even sure if that is the correct name. Does anybody know who makes it. Although there are some paint drips on it they come off very easily. It is very well made and the slide table is on roller bearings. There is a Maple Leaf Flag so I assume it is made in Canada. I just connected it up without adjustments. What is something like this worth? I really have no need for it and it just takes up too much space when stored.http://s35.photobucket.com/albums/d186/Barrier_/?action=view&current=uni66.jpg
Thanks for help.
Robert
Nancy Laird
07-18-2007, 12:30 AM
Robert, the expert in our family says that this is a 66" Excaliber sliding table. New ones are right around $800, but they are now being made by General in China. This one is probably worth $400.00.

Nancy
Andre Masse
07-18-2007, 8:53 AM
Excalibur sliding table web site here :

http://www.general.ca/excalibur/pagemach/ang/50_slt40_60.html
Robert Conner
07-18-2007, 9:05 AM
Yes that is it!
Anybody need it?
I am going to clean up the paint splatters and post it in the classified section or maybe CL. It is really perfect except for the splatters.
Wish I had room for it, I don't even have enough space for the side extension table I have, I'm going to just use a portable roller.
Thanks for the help.
Robert
John Shuk
07-18-2007, 11:15 AM
Where are you located?
Robert Conner
07-18-2007, 11:40 AM
John I PMd you.
Robert
John Shuk
07-18-2007, 2:14 PM
PM sent back at you.
frank shic
07-18-2007, 4:03 PM
That table saw accessory was well worth the $500 I bought it for on craigslist last year. It has revolutionized my approach to cabinetmaking by allowing me to make FINISH cuts with the first few passes.
John Lucas
07-19-2007, 8:09 AM
Robert,
It looks like the Excalibur but is in fact the Exaktor version of the same. You can tell by the use of the stainless steel rectangular slide pieces. It is a good unit and their webpage is: http://www.exaktortools.com/
Robert Conner
07-19-2007, 9:24 AM
Thanks for the insight John.
In any event I am selling it, I just don't have the room. As soon as I clean it up I will post it on classified, then on CL if no one here needs it.
Robert
Jim Becker
07-19-2007, 10:43 AM
I am going to clean up the paint splatters and post it in the classified section or maybe CL. It is really perfect except for the splatters.

Hmm...I was not thinking "paint" when I saw those splatters!! :D