Larry Rasmussen
07-15-2007, 1:50 PM
I'm just walking out to get my new table set up, went commercial this time and have a jessem mast-R fence and a typical table top, about 22 X 32, I'm just too lazy to go measure.
I'll be running a collection line into a sealed box under the table. I will either wye off that hose and run up to the top with a 2 1/2" hose or just put another port on the box under the table and run a hose up from that to the collection on the fence.
I think I've reviewed most of the material here. In the past I've just used a collector from above attached to the fence. I have a choice of either using my Jet 1HP collector with cartridge filter or the turbo II vac by Fein I've been using. Both will be hooked up and in good position.
Questions for the panel:
1. I'm inclined to use the Jet, any dissenting opinions?
2. Am going to run 2 1/2 hose to port above table on fence. Should I use 4" into box under table or stick with 2 1/2 all the way from main line (6-8 feet).
3. Any body do this and have trouble balancing the two levels of suction between top and bottom?
4. Any ideas about how big the box should be? Woodpecker's is about 9" X 12" X 11". Seems small. Is this parameter of much importance?
Thanks in advance for any comments.
Larry R.
I'll be running a collection line into a sealed box under the table. I will either wye off that hose and run up to the top with a 2 1/2" hose or just put another port on the box under the table and run a hose up from that to the collection on the fence.
I think I've reviewed most of the material here. In the past I've just used a collector from above attached to the fence. I have a choice of either using my Jet 1HP collector with cartridge filter or the turbo II vac by Fein I've been using. Both will be hooked up and in good position.
Questions for the panel:
1. I'm inclined to use the Jet, any dissenting opinions?
2. Am going to run 2 1/2 hose to port above table on fence. Should I use 4" into box under table or stick with 2 1/2 all the way from main line (6-8 feet).
3. Any body do this and have trouble balancing the two levels of suction between top and bottom?
4. Any ideas about how big the box should be? Woodpecker's is about 9" X 12" X 11". Seems small. Is this parameter of much importance?
Thanks in advance for any comments.
Larry R.