William Wilkie
07-13-2007, 11:17 PM
Hello All,
Do any of you guys have any history of trying to laser engrave Gravoply 1 (not meant for a laser). I have a customer that really likes this stuff, I am running a laser (model below). I have a whole lot of plates to run.
Also is there a "general" dummies guide to laser engraving, tips, hints, power and speed setting, etc. anywhere online ?
I run mostly Gravoply Ultra .062" and some Anodized aluminum plates.
This site has been a great deal of help, you guys really do a great job of sharing information.
Thanks and Best Regards,
Do any of you guys have any history of trying to laser engrave Gravoply 1 (not meant for a laser). I have a customer that really likes this stuff, I am running a laser (model below). I have a whole lot of plates to run.
Also is there a "general" dummies guide to laser engraving, tips, hints, power and speed setting, etc. anywhere online ?
I run mostly Gravoply Ultra .062" and some Anodized aluminum plates.
This site has been a great deal of help, you guys really do a great job of sharing information.
Thanks and Best Regards,