pattern routing

[joe zarnitz]

on a router table to pattern rout a circle is the work turned cw or ccw ---tks,joe

[Randy Klein]

Not sure, but just think of the rotation of the bit, and feed the piece into the rotation, as opposed to with it.

[Lee DeRaud]

Not sure, but just think of the rotation of the bit, and feed the piece into the rotation, as opposed to with it.And unless you've rewired your router to run backwards, that works out to counter-clockwise.

[Norman Hitt]

The direction will depend on whether you are routing the inside edge of a circle or the outside edge of a circle. For the Inside of a circle, go clockwise, and for the outside of a circle, go counterclockwise.

[Cliff Rohrabacher]

ooops wrong thread

[Eddie Darby]

And If you are in the Southern Hemisphere? :D