View Full Version : Reeves Pulley
Joe Scarfo
07-08-2007, 4:41 PM
The drive pulley (the one on the motor) on my Delta Iron Bed Lathe has given up the ghost. I've called everyone and the part isn't available untill the end of Sept.
Some may understand I'm in no mood to wait that long, I'm going through withdrawls now.
Any feedback on the best purveyor of reeves pulley's?
Thanks
Joe Scarfo
Dick Strauss
07-09-2007, 4:10 PM
Joe,
I assume you don't want to use Delta pulleys, right?
Try these sites...don't know anything about the co's but they might be able to help you:
http://bearingheadquarters.birkey.com/supplier.asp?supplier_id=78
http://www.talonbearing.com/power_transmission_products.htm#variable_speed_bel ts
http://www.speedselector.com/fixer.htm
http://www.hi-lo.com/pages/products12-99.html
http://www.bearingind.net/powertrn.htm
http://www.pggears.com/products.htm
Charles Bruno
07-09-2007, 5:49 PM
Joe,
I've used the following company for replacement bearings, pulleys, gears & sprockets on a number of items through out the years its, Kaman industrial at
http://www.kamandirect.com/
Hope this helps, Have you checked any industrial supply places in your area?
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.