Bob Cole
06-26-2007, 4:28 AM
I have a ULS X-660 connected Ethernet with a DP-301P+ and had an odd issue when I sent the next file to the printer before it was finished with the last job.
I haven't found in the documentation where you can't do this, but noticed my laser slow down slightly when I sent the job and when I went to start the next job, I got an error about the job was corrupt.
I haven't tried it again because I have been working on a few projects so wasn't sure if this is a fluke or it is understood to only send one job at a time.
I haven't found in the documentation where you can't do this, but noticed my laser slow down slightly when I sent the job and when I went to start the next job, I got an error about the job was corrupt.
I haven't tried it again because I have been working on a few projects so wasn't sure if this is a fluke or it is understood to only send one job at a time.