Help - Drill Press Jig

[Kenneth D. Stein]

I need to bore holes on a 10 degree angle on 1x4 stock. Can someone please help me to visualize a jig that would hold the 1x4 stock at the right angle so that the holes can be bored straight.

Thanks

[Gary Keedwell]

Can you tilt your DP table to 10 º? How about cutting a 4X4 on chop saw at 10 º....go down couple of inches and cut regular 90º.
That's the omly two ways I can think of off the top of my head.
Gary K.

[Ralph Barhorst]

Take a look at this.
http://www.bobsplans.com/FreeJigPlans/PocketHoleJig/PocketHoleJig.htm

This was designed to drill pocket holes at 15*, but it can be adapted for 10*.

[Brian Gumpper]

I use use another piece of wood clamped to the drill press table as a stop and set spacing using a small diameter bit. Then tilt the table and your done. Couldn't hurt to clamp down the piece your drilling into also.