Byron Trantham
06-10-2007, 11:37 AM
I just received my Wixey angle gage and boy it's one nice tool. I ran around the shop and checked everything to see if they "square". To my surprise, they were!:D I have a Unisaw and cranked it to the 45 degree stop and checked it. 45.1 degrees! I didn't check my SCMS (12" DeWalt slider)for 45 degrees (laid over to the left or right) because I never use it to make those cuts. I use it to make 45s on the vertical but the Wixey can't check that relationship. I think I will put this tool to good use.:D