Chuck Beland
06-09-2007, 12:38 PM
Well one of my customers wanted a ring bowl like the one I made for LOML.
I bought some 8/4 Bubinga from Woodcrafters it's 12" wide x 26" long
She wanted it smaller so this is the result 1st attempt is the bowl on the right second is the bowl on the left. so far I have had about 10 catches making both bowls even with the DAM round scraper :evil: I am using a Pinnacle 3/8" bowl gouge & I have blown up 5 attempts at making the finger. Good thing I was wearing my face shield I had one bounce off it. It would have caught me right in the schnozz :roll: I even got a couple of catches making the bead for the rim using a spindle gouge
No more turning today I know when to quit.
http://i26.photobucket.com/albums/c117/xxxrecon/bowls.jpg
http://i26.photobucket.com/albums/c117/xxxrecon/bowls1.jpg
I bought some 8/4 Bubinga from Woodcrafters it's 12" wide x 26" long
She wanted it smaller so this is the result 1st attempt is the bowl on the right second is the bowl on the left. so far I have had about 10 catches making both bowls even with the DAM round scraper :evil: I am using a Pinnacle 3/8" bowl gouge & I have blown up 5 attempts at making the finger. Good thing I was wearing my face shield I had one bounce off it. It would have caught me right in the schnozz :roll: I even got a couple of catches making the bead for the rim using a spindle gouge
No more turning today I know when to quit.
http://i26.photobucket.com/albums/c117/xxxrecon/bowls.jpg
http://i26.photobucket.com/albums/c117/xxxrecon/bowls1.jpg