Tom Henderson2
06-05-2007, 4:49 PM
Greetings. It looks like I may be buying a used Unisaw. It will be transported in a low trailer, so I need to make some ramps to get it down onto the driveway.
The saw is on a Delta mobile base.
Anybody out there know the approximate "wheelbase" for the Unisaw? I was going to make a plywood-and-2x4 ramp and want to make sure it is wide enough.....
I'm guessing that 2' is too narrow but 4' would be more than enough. A 24" wide ramp would be easier to make out of materials on hand but I doubt it will do the job.
Thanks in advance!
The saw is on a Delta mobile base.
Anybody out there know the approximate "wheelbase" for the Unisaw? I was going to make a plywood-and-2x4 ramp and want to make sure it is wide enough.....
I'm guessing that 2' is too narrow but 4' would be more than enough. A 24" wide ramp would be easier to make out of materials on hand but I doubt it will do the job.
Thanks in advance!