william kennington
05-28-2007, 8:54 PM
Good Evening Laser Guru's,
Like many folks here, I have been reading this forum for a while now and must say I am duly impressed. I work in a family sign shop a few days a week and have recently purchased a new Pinnacle M series laser. Unfortuneately the folks I bought it from failed to include the laser software. I am using Corel x3 at the moment. (not very familiar with yet) The question is, do I set the page size to correspond to the work being engraved? In the driver setup it says the table size is always set to 25" x 18". I am pretty familiar with Flexi for the sign industry and we always set the dimensions to the work being designed. :cool:
Like many folks here, I have been reading this forum for a while now and must say I am duly impressed. I work in a family sign shop a few days a week and have recently purchased a new Pinnacle M series laser. Unfortuneately the folks I bought it from failed to include the laser software. I am using Corel x3 at the moment. (not very familiar with yet) The question is, do I set the page size to correspond to the work being engraved? In the driver setup it says the table size is always set to 25" x 18". I am pretty familiar with Flexi for the sign industry and we always set the dimensions to the work being designed. :cool: