View Full Version : Another Newbie Question

william kennington
05-28-2007, 8:54 PM
Good Evening Laser Guru's,
Like many folks here, I have been reading this forum for a while now and must say I am duly impressed. I work in a family sign shop a few days a week and have recently purchased a new Pinnacle M series laser. Unfortuneately the folks I bought it from failed to include the laser software. I am using Corel x3 at the moment. (not very familiar with yet) The question is, do I set the page size to correspond to the work being engraved? In the driver setup it says the table size is always set to 25" x 18". I am pretty familiar with Flexi for the sign industry and we always set the dimensions to the work being designed. :cool:

Matty McQuilkin
05-28-2007, 10:51 PM
Always set the page size to the of the table in my case 24 x 18

Under your printer options.
Layout tab: select top left hand corner

Under Properties/ Advanced: select relative. This allows you to start engraving any ware on the laser table. That is any where you move the laser head.

Center. Allows you to put the red beam in the center of what you want to laser.

Hope that helps