Larry Rasmussen
05-28-2007, 11:26 AM
Got my case of slides from Glideright and I'm ready to build a few drawers. Will start with a dedicated table for my bench top drill press. Somewhere around 18" X 18" by 36" tall. I'll probably go with 5 drawers.
I figured I'd just lay it out on paper- put the cabinet slides on inside of cabinet before assembly for this euro style box. Next step put the drawer half of the slides on the drawers per my pre planned lay out, put them in the cabinet, finish with second face to adjust out any imperfections in fit.
I'm always ready to buy a little jig to make life easier and the ads for the Kreg jigs make it sound like the lay out process is so tough you need a jig to directly lay out slides on both the cabinet side and drawer to get good results.
How to you guys plan and implement the drawer locations and installation?
Thanks for any insight,
Larry
I figured I'd just lay it out on paper- put the cabinet slides on inside of cabinet before assembly for this euro style box. Next step put the drawer half of the slides on the drawers per my pre planned lay out, put them in the cabinet, finish with second face to adjust out any imperfections in fit.
I'm always ready to buy a little jig to make life easier and the ads for the Kreg jigs make it sound like the lay out process is so tough you need a jig to directly lay out slides on both the cabinet side and drawer to get good results.
How to you guys plan and implement the drawer locations and installation?
Thanks for any insight,
Larry