Bosch Miter saw tuning ?

[Eugene A. Manzo III]

Has anyone ever tuned up a Bosch saw ? The manual gives instructions only on tuning up bevels not angles on the table.

[Mike Henderson]

I'm not sure if I understand what you mean by "angles on the table". But if you're talking about the angles indicated in the front of the saw, I think the only adjustment you can make in that plane is to set the 90* (0* as indicated on the guide) cut by adjusting the fence. You adjust the fence by slacking the bolts holding the fence and then use an accurate square to set the fence 90* to the blade. This is described in my Bosch manual.

What model is your Bosch CMS?

Mike

[Eugene A. Manzo III]

I have a Model 4410 and you are right that is what it says in my manual .
I will check 0 position out tomorrow but I think thats ok just 45 out about 1 deg. I do love the saw though it is very nice. Thank You !!

[Mike Henderson]

I have the 4212 so mine may not adjust the same as yours. Mine cuts 45's pretty good. I had to cut some miters just recently and had no problems with the fit.

Mike