John Myers
05-23-2007, 12:51 PM
Just wondering - can the Jointech smartmiter be used on a router table? Anyone use it for routing tenons on a router table?
John
Jim O'Dell
05-23-2007, 1:42 PM
I would imagine that it would work, but that would have to be a big router table. (Not unlike the size that I am planning on:D , but larger than the typical table top) Sounds like an Incra system is in your future! On the other hand, if you have a TS mounted router plate, and you can adjust it to the right length away from the right side miter slot, then that might be doable. Jim.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.