Jointech smartmiter on a router table?

[John Myers]

Just wondering - can the Jointech smartmiter be used on a router table? Anyone use it for routing tenons on a router table?

John

[Jim O'Dell]

I would imagine that it would work, but that would have to be a big router table. (Not unlike the size that I am planning on:D , but larger than the typical table top) Sounds like an Incra system is in your future! On the other hand, if you have a TS mounted router plate, and you can adjust it to the right length away from the right side miter slot, then that might be doable. Jim.