View Full Version : Drill Ques
Garth Keel
05-12-2007, 5:01 PM
I just picked up an Millers Falls drill in exc cond and too good a price for me to pass up. Now, What kind of bits can I use and where can I find them? (no pic yet)
glenn bradley
05-12-2007, 5:38 PM
What kind of chuck do you have Garth? Is it a Brace?
Garth Keel
05-12-2007, 9:15 PM
It is in the mail so I am not sure of the difference. It is an "egg beater" type. Is a brace the one one that looks like a large "C"?
Mike K Wenzloff
05-12-2007, 9:21 PM
Hi Gath,
You can use regular twist drill bits and small brad points as long as the shan fits in the chuck. Several different sizes were made with some intended for small bits, but the larger egg beater drills can handle larger shanks.
Yep, braces have the handle which is off axis from the pad and chuck. Here's a few...
Ones with the Spofford type chuck:
http://www.wenzloffandsons.com/temp/braces_0001.jpg
And ones with ratcheting chucks:
http://www.wenzloffandsons.com/temp/braces_0002.jpg
Take care, Mike
Garth Keel
05-12-2007, 9:24 PM
Thanks; Mike it seems you have more drills than hands!
Mike K Wenzloff
05-12-2007, 9:33 PM
Nah, for the most part, I keep various different bits and counter sinks and what not in each one.
Braces and drills can be a slippery slope all its own--so be careful!
Take care, Mike
Jerry Palmer
05-14-2007, 3:25 PM
I've even spun some smaller forstners in my larger egg beater.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.