Dennis Kelly
05-10-2007, 12:21 PM
Hello,
I am just about finished with a mother's day project which is a plant stand. The frame was squared and assembled, but when I attached the table top, the frame shifted a bit off square which caused the stand to be unlevel and a little wobbly.
I was wondering if any of you have any tricks or tips that you use to address this problem, or if I'm failing in other areas of the construction. I was thinking of using a coping saw to trim a bit off of the high legs that are causing the wobbling.
Dennis
I am just about finished with a mother's day project which is a plant stand. The frame was squared and assembled, but when I attached the table top, the frame shifted a bit off square which caused the stand to be unlevel and a little wobbly.
I was wondering if any of you have any tricks or tips that you use to address this problem, or if I'm failing in other areas of the construction. I was thinking of using a coping saw to trim a bit off of the high legs that are causing the wobbling.
Dennis