Nancy Laird
05-05-2007, 4:44 PM
OK, I'm stumped by this one--I've never had this happen before.
I'm using Corel X3 on a ULS M-360 (40W), and trying to engrave some designs on picture-frame glass. The glass is 7x7", engraving area is 6-1/2" square. I imported some clip art into the graphic, did a little clean-up, and all looks real pretty on the screen.
Send to print, and get an issue that says that the output doesn't fit the media! :confused: Send to print anyway, it starts printing, gets about 1/3 to 1/2-way done with the design, and says it's done--and the design that DOES get printed is about 1-1/2" down from the top where it's supposed to be (so it's printing on my cutting table!! :mad: .
I've tried the "fit to page" option, and that puts the image even more away from the place where it's supposed to be.
I've never had this problem before--the graphic fits entirely within the 7x7 area. Any suggestions??
Thanks,
Nancy
I'm using Corel X3 on a ULS M-360 (40W), and trying to engrave some designs on picture-frame glass. The glass is 7x7", engraving area is 6-1/2" square. I imported some clip art into the graphic, did a little clean-up, and all looks real pretty on the screen.
Send to print, and get an issue that says that the output doesn't fit the media! :confused: Send to print anyway, it starts printing, gets about 1/3 to 1/2-way done with the design, and says it's done--and the design that DOES get printed is about 1-1/2" down from the top where it's supposed to be (so it's printing on my cutting table!! :mad: .
I've tried the "fit to page" option, and that puts the image even more away from the place where it's supposed to be.
I've never had this problem before--the graphic fits entirely within the 7x7 area. Any suggestions??
Thanks,
Nancy