Cutting wedges

[Dick Heifner]

Hi All,
I need to cut some wedges about 3" wide with a taper of 15deg, these are about 9" long. What would be the safest way to do this?
These will be mounting blocks for retractable casters for my workbench.
Thank's,
Dick

[Fred Voorhees]

I'm sure that with a little planning, a jig (or combination of jigs) to use with your tablesaw wouldn't be that hard to work up.

[Eddie Darby]

Sounds like a job for the band-saw!

[glenn bradley]

Bandsaw and then joint the sawn surface if required or hand plane, belt sand, etc.

[Jim Becker]

I do wedges on the band saw.

[Don Bullock]

Sounds like a job for the band-saw!


I do wedges on the band saw.

One more vote for band saw.:D

[Dick Heifner]

All,
Thanks for your ideas.
Dick