Keith Outten
12-30-2003, 8:48 PM
Ol' Keith's Layout Gage
My circle/angle layout Gage is finally ready for testing. All of the text has been enlarged and is easier to read as well as a few last minute changes to the design.
My Gage is made from 1/8" clear acrylic, the small black dots are actually holes sized for a standard pencil point. The Gage will layout any angle and scribe circles up to 10" in diameter in 1/8" increments. They are produced on the laser engraver and the drawing was done mathematically by Aaron via a Corel script so they should be very accurate.
These are the people who responded to my request for comments on another thread and I promised them a free Gage to shop test.
Ken Garlock
Steve Clardy
Brad Schafer
Doug Keener
Bob Oswin
Tony Falotico
If you guys will make sure I have your shipping address (via email) I will ship the gages to you Monday morning. After you have had time to use them any comments you have would be appreciated.
My circle/angle layout Gage is finally ready for testing. All of the text has been enlarged and is easier to read as well as a few last minute changes to the design.
My Gage is made from 1/8" clear acrylic, the small black dots are actually holes sized for a standard pencil point. The Gage will layout any angle and scribe circles up to 10" in diameter in 1/8" increments. They are produced on the laser engraver and the drawing was done mathematically by Aaron via a Corel script so they should be very accurate.
These are the people who responded to my request for comments on another thread and I promised them a free Gage to shop test.
Ken Garlock
Steve Clardy
Brad Schafer
Doug Keener
Bob Oswin
Tony Falotico
If you guys will make sure I have your shipping address (via email) I will ship the gages to you Monday morning. After you have had time to use them any comments you have would be appreciated.