View Full Version : chatter tool
Paul Zerjay
04-24-2007, 4:49 PM
Has anyone made a chatter tool? I've tried bandsaw blades, hacksaw blades, and whatever else I could think of and have had no luck. I've looked at alot of threads dealing with this, and can't seem to come up with anything that works consistantly. Thanks for the help. Paul
Keith Burns
04-24-2007, 4:55 PM
Paul, try this link. John Lucas has an article on how to make them. www.cumberlandwoodturners.com (http://www.cumberlandwoodturners.com)
Paul Zerjay
04-24-2007, 5:03 PM
Keith, thats the exact link I've been experimenting with. It works fine on hard Maple like in the pic, but no good on a softer wood such as Holly. I guess I can't use the Holly.
Keith Burns
04-24-2007, 5:08 PM
Sorry Paul, thats the only place I've seen one. I have a chatter tool but have never used it.
Jonathon Spafford
04-24-2007, 6:24 PM
Keith, thats the exact link I've been experimenting with. It works fine on hard Maple like in the pic, but no good on a softer wood such as Holly. I guess I can't use the Holly.
Bonnie Klein uses it on holly all the time in her movies... don't know why it wouldn't work!
Gordon Seto
04-24-2007, 7:00 PM
Chattering tool works on end grain hard wood only. You can't get a crisp pattern on soft wood.
Gordon
Jerry Gilman
04-24-2007, 7:34 PM
It will work fine on Holly, do the following.
1- The blade should only extend 1/2 to 3/4 inch from holder
2- Use a sharp very small burr (a large burr will tear out the wood)
3- Raise the tool rest so when the blade tip is held at a 45 degree
decline it is at the same height as the works center.
4- After cutting the chatter, burnish the chatter with a small dowel
(rounded tip) at 500 rpm
Joe Collazo
04-24-2007, 8:25 PM
I made one a couple of months ago. It uses a cheap jigsaw blade. You can read more and see pictures here: http://www.penturners.org/forum/topic.asp?TOPIC_ID=22352
Hope this helps.
joe
Jerry Gilman
04-25-2007, 6:03 AM
Go to http://www.robert-sorby.co.uk/
click on movie clips, scroll down to chattertool to play videos.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.