Looney Laser

[Ed Garrett]

Help.

Does anyone have experience with this problem:

I've got a Delta Twin Laser 12" miter saw a few months back. It shines a laser line on both edges of the kerf. It worked great for a while, but now the right laser has gone nuts. It's stuck at about a 15 degree angle and won't adjust back to parallel to the blade. It also won't adjust back to within about 1 cm of the blade.

Should I take it apart or start down the road toward warranty service???

Thanks for the help.

Ed Garrett
Tallahassee, FL

[Bill Huber]

Help.

Does anyone have experience with this problem:

I've got a Delta Twin Laser 12" miter saw a few months back. It shines a laser line on both edges of the kerf. It worked great for a while, but now the right laser has gone nuts. It's stuck at about a 15 degree angle and won't adjust back to parallel to the blade. It also won't adjust back to within about 1 cm of the blade.

Should I take it apart or start down the road toward warranty service???

Thanks for the help.

Ed Garrett
Tallahassee, FL

I would start with the customer service at Delta and see what they have to say. I have found that when I call the customer service department of most of the companies they will take care of the problem.
If you start taking it apart and something goes wrong then you could screw up your warranty.


Good luck..