Ed Garrett
04-18-2007, 8:26 PM
Help.
Does anyone have experience with this problem:
I've got a Delta Twin Laser 12" miter saw a few months back. It shines a laser line on both edges of the kerf. It worked great for a while, but now the right laser has gone nuts. It's stuck at about a 15 degree angle and won't adjust back to parallel to the blade. It also won't adjust back to within about 1 cm of the blade.
Should I take it apart or start down the road toward warranty service???
Thanks for the help.
Ed Garrett
Tallahassee, FL
Does anyone have experience with this problem:
I've got a Delta Twin Laser 12" miter saw a few months back. It shines a laser line on both edges of the kerf. It worked great for a while, but now the right laser has gone nuts. It's stuck at about a 15 degree angle and won't adjust back to parallel to the blade. It also won't adjust back to within about 1 cm of the blade.
Should I take it apart or start down the road toward warranty service???
Thanks for the help.
Ed Garrett
Tallahassee, FL