View Full Version : Attempt at Eagle Tail joint
Mark Valsi
04-13-2007, 11:41 AM
I tried to make this joint as described in the INCRA book
Took a few "test" cuts to get it as good as I could
Jim Becker
04-13-2007, 11:48 AM
Very cool! Do you have any pictures while "in progress" you can share?
glenn bradley
04-13-2007, 11:58 AM
Interesting joint. It's cool how from different angles you get a subtle difference of impression about the box.
Eric Wong
04-13-2007, 11:59 AM
Sweet box....did you use a jig or go Neander?
John Schreiber
04-13-2007, 12:10 PM
That's confusing to look at when it's done. It must have been super confusing to visualize and make.
Jeff Craven
04-13-2007, 12:42 PM
Are all four sides tapered?
Cliff Rohrabacher
04-13-2007, 2:54 PM
That's confusing to look at when it's done. It must have been super confusing to visualize and make.
It is a little bezuuzzling to the eyes isn't it.
Way cool joint.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.