Could use some help from a local Electrician

[Steve knight]

Though the guy I lease my shop space from is good at wiring he is not sure about doing my cnc router. The 120 is ok but the 3 phase to the spindle can be tricky. It calls for a fused shutoff box too. If someone here in Portland or close wants to trade plane (s) to get me hooked up it would be great. There might be some noise issues from the spindle I need help with (though I hope not)

[Ryan Myers]

Buy the materials and me a plane ticket and I will come and do it for you:D Seriously, I would do it without hesitation if I was closer. I've hooked up a few CNC routers, make sure to get a real electrician involved especially if your spindle is controlled by a VFD.

[Steve knight]

Buy the materials and me a plane ticket and I will come and do it for you:D Seriously, I would do it without hesitation if I was closer. I've hooked up a few CNC routers, make sure to get a real electrician involved especially if your spindle is controlled by a VFD.
yes thats what I am after but I don't know what what I need to hook the spindle up. it calls for a fused cutoff but I don't have any details. here is spindle a 4hp 3 phase on a vfd. http://www.knight-toolworks.com/pictures/shopbot3.JPG

[Jim Dunn]

Call most large electrical supplier and they can handle your needs of a fused disconnect. I think that's what your looking for. I just bought one for my newest thread here. About $212.00 with the 60amp fuses.

[Steve knight]

is this what I need? I only need 20 amps though http://tinyurl.com/28muk2