Ted Baca
04-07-2007, 12:47 AM
Here is my dilemma. I can only afford and power (AC wise) a 110/120 volt tool. I am looking at the Jet 22CS 1.5 HP Router Shaper with 7000 and 9000 RPM
reversable arbor. Or buy a good router table and use a 3hp router. My use will most likely be edge shaping, jointery, dados, some panel shaping, and very little if any molding. So what would you recommend? I have looked at the Jess-em more dough but nice, Bench Dog and a few other router tables. I haven't found another 1.5 HP 120volt shaper to compare the Jet to. The Jet offers reversability of the arbor but when would I need that? Please share your experience with me. I got good advice here when I bought my SawStop and have been 100% satisfied. I thought I would tap into this resource once again. Thank you in advance.
PS Happy Easter to all!
reversable arbor. Or buy a good router table and use a 3hp router. My use will most likely be edge shaping, jointery, dados, some panel shaping, and very little if any molding. So what would you recommend? I have looked at the Jess-em more dough but nice, Bench Dog and a few other router tables. I haven't found another 1.5 HP 120volt shaper to compare the Jet to. The Jet offers reversability of the arbor but when would I need that? Please share your experience with me. I got good advice here when I bought my SawStop and have been 100% satisfied. I thought I would tap into this resource once again. Thank you in advance.
PS Happy Easter to all!