Craig D Peltier
03-29-2007, 8:39 PM
Hello creeks, I finally got my 8 inch griz jointer today. I have wired the motor, the plug im putting on the cord is where i have the question. Plug has 3 wires, wire has 3 wires good so far. Green is ground plug clearly states G, i put that to ground wire which is green. Then theres two wires left a white an black.Looking at the wiring diagram there both hot.Okay good.
Heres where my question is, the plug says x and y thats the two openings left. Can I do either one for either wire since there both hot. The male terminlas look the same that plug into the wall that there going into.Looks like one hot goes to Stop/reset switch the other to power light.
Thanks
Im clueless when it comes to wiring but I have been piddling with it a bit lately.
Heres where my question is, the plug says x and y thats the two openings left. Can I do either one for either wire since there both hot. The male terminlas look the same that plug into the wall that there going into.Looks like one hot goes to Stop/reset switch the other to power light.
Thanks
Im clueless when it comes to wiring but I have been piddling with it a bit lately.