richard poitras
03-24-2007, 8:19 PM
I recently came across this Thomas pump(shipping only) and was just wondering if it would work for a veneering vacuum bag system (Joe woodworker’s kit) I know that that cfm is vary low and I was just wondering what the general consensus is as fare as if it would work? Meaning as fare as bringing the bag down fast I know that is out of the question, but would it still put enough vacuum presser on doing veneering and possibly bent lamination?
The sticker has the model #107CAB18 and then below it has 110/115v (I always thought 110 + 115 was the same thing) The 110v is rated @ 0.58 cfm and the 115v is rated @ 0.69 cfm ….
Here's the link of the model:
http://www.rtpumps.com/rtpumps/us/she/en/home.nsf/systemcontentview/index.html?Open&DirectProductURL=B9B8BEF37557CA2FC 1256F240023D167 (http://www.rtpumps.com/rtpumps/us/she/en/home.nsf/systemcontentview/index.html?Open&DirectProductURL=B9B8BEF37557CA2FC1256F240023D167)
The sticker has the model #107CAB18 and then below it has 110/115v (I always thought 110 + 115 was the same thing) The 110v is rated @ 0.58 cfm and the 115v is rated @ 0.69 cfm ….
Here's the link of the model:
http://www.rtpumps.com/rtpumps/us/she/en/home.nsf/systemcontentview/index.html?Open&DirectProductURL=B9B8BEF37557CA2FC 1256F240023D167 (http://www.rtpumps.com/rtpumps/us/she/en/home.nsf/systemcontentview/index.html?Open&DirectProductURL=B9B8BEF37557CA2FC1256F240023D167)