Rusty Hughes, Indy
12-20-2003, 10:47 AM
Hello,
I had some tear out when drilling the 10 mm hole in a amboyna burl pen blank. The tear out happened deep enough that the brass tube is exposed by about 1/16". This is the upper barrell and the tear out happened at the cap end. Can I trim this barrell down that much? If I can't do you have any ideas on how to save this blank?
Thanks
I had some tear out when drilling the 10 mm hole in a amboyna burl pen blank. The tear out happened deep enough that the brass tube is exposed by about 1/16". This is the upper barrell and the tear out happened at the cap end. Can I trim this barrell down that much? If I can't do you have any ideas on how to save this blank?
Thanks